M12 Cable Tester PCB Design
Execution stopped due to insufficient credits.
0:39
Accessing knowledge.
Started: inspecting pins and wiring continuity nets.
Thought
Work done
- Captured the M12 cable tester plan and inspected the empty project state.
- Searched the library for the required interfaces and found usable board-mount M12 receptacles plus 4-position terminal blocks.
- Added the connector and indicator set: J1, J2, J3, J4, J5, J6, D1, D2, D3, D4, R1, R2, R3, R4.
- Set the project description to document the tester purpose and the brown/white/blue/black pin labeling scheme.
- Inspected the added components and confirmed their available pin names for the next wiring step.
Success criteria review
- ✅ Required terminal blocks and M12 connector interfaces have been added to the project.
- ❌ The continuity nets are not yet wired, so the LED channels are not electrically functional yet.
- ❌ The schematic is not yet complete and has no routed connection paths between the connector sets and indicator circuits.
Next steps
The remaining work is to wire the four 1-to-1 continuity channels, connect each LED + resistor path so it only lights for the matching pin path, label the channel nets, and then review the schematic and layout readiness. I could not continue because execution in this session is blocked.
Welcome 👋
Flux helps you build PCBs faster with an AI teammate!
Create your account to collaborate, stay updated, fork your own version, and get instant answers from our AI agent.