Multiple decoupling capacitors on the ESP32’s power pins serve to filter noise across a very wide frequency range. Each value has its own “sweet-spot” impedance vs. frequency curve, so by combining them you get low impedance from DC up into the hundreds of megahertz.
| Capacitor Value | Purpose | Frequency Range Filtered |
|-----------------|-------------------------------------------|--------------------------------|
| 10 µF (bulk) | Holds up the rail for large, slow transients (e.g. Wi-Fi bursts) | DC – a few MHz |
| 0.1 µF (mid-range) | Local energy reservoir for medium-speed switching | ~1 MHz – 50 MHz |
| 0.01 µF or less (high-freq) | Snubs very fast spikes and RF noise | 50 MHz – hundreds MHz |
By placing:
– a **large bulk cap** close to your regulator,
– a **100 nF** right beside the ESP32 [IC1](https://www.flux.ai/:handle/:documentSlug?fit=IC1), and
– a **small high-frequency cap** (e.g. 10 nF or lower) right at the power pin itself
you ensure that switching currents and RF bursts from the ESP32 have a low-impedance path to ground at all relevant frequencies, preventing supply-rail dips, oscillation, and RF-induced glitches.