PCB 3D Render


Created and attached a realistic 3D model for the E01-ML01DP5 module, including the PCB, 12 pins, RF shield, and SMA connector. Verified correct scale, seating, SMA orientation, and pin-1 alignment.

3D Model

  • Module envelope and connector dimensions follow the official drawing.
  • Shield details and 1.0 mm PCB thickness are nominal because those dimensions are not fully specified.
Refine the shield-can geometry if you can find a more detailed mechanical drawing.
I’ll search for a module-specific drawing with shield dimensions, then update the model only if the new source is more authoritative than the current image-based estimate. I’ll recheck the shield’s fit, scale, and seating afterward.
I’ll compare this V1.2 manual directly against the V1.3 imagery used for the refinement and update the shield again only if it contains clearer or dimensioned geometry.
Compared the supplied V1.2 manual against V1.3. Its estimated shield size agrees with the current 23.75 × 16.96 mm model but provides no additional dimensioned details, so no speculative changes were made; the model remains verified at scale 1 with correct alignment and seating.
Inspect 3D model
Check footprint dimensions
Add antenna keepout
Improve silkscreen

Pin #
Name
Type
Section
Pin Group
Orientation
Order
Sub-symbol
1
GND
Unspecified
2
VCC
Unspecified
3
CE
Unspecified
4
CSN
Unspecified
5
SCK
Unspecified
6
MOSI
Unspecified
7
MISO
Unspecified
8
IRQ
Unspecified
9
9
Unspecified
10
10
Unspecified
11
11
Unspecified
12
12
Unspecified

E01-ML01DP5