U3 to IC1 Transfer
Thought for 8 mins 52 sec
Received notification from "TPS63802 Stage 2 Verification" that it finished — picking the work back up.
Thought for 12 sec
Phase B has been built. I’m reconciling the executor’s report now, then a fresh reviewer will independently check the destructive switch-node and feedback conditions before I close Stage 2.
Thought for 1 min 36 sec
Received notification from "TPS63802 Audit" that it finished — picking the work back up.
Thought for 7 sec
Stage 2 build is complete:
- U3 TPS63802DLAT installed and wired
- L3 replaced with Murata
DFE201612E-R47M=P2 - R13/R25 feedback divider added
- Critical switch nodes reported correctly separated: U3 pin 7/L3 pin 2=
REG_SW2; U3 pin 9/L3 pin 1=REG_SW1 - PG is explicitly unconnected;
PGOOD_Nunchanged - Initial ERC reported clean
The independent audit finished, but I cannot retrieve and reconcile its final report because no ACUs remain. That reconciliation, the full 12-item report, and final Stage 2 sign-off remain pending; no further project changes should be made until the audit is reviewed.
Reconcile the TPS63802 audit
Review remaining design checks
Verify regulator implementation
Document Stage 2 decisions
