Sensors
Seeed Studio XIAO ESP32S3 Sense
Seeed Studio XIAO ESP32S3 leverages dual-core ESP32S3 chip, supporting both Wi-Fi and BLE wireless connectivities, which allows battery charge. It integrates built-in camera sensor, digital microphone. It offers 8MB PSRAM, 8MB FLASH, and external SD card slot. All of these make it suitable for embedded ML, like intelligent voice and vision AI.
49 Uses
3 Stars
MQ-2
MQ-2 is a smoke and combustible gas sensor from Winsen. It can detect flammable gas in a range of 300 - 10000ppm. It's most common use is domestic gas leakage alarms and detectors with a high sensitivity to propane and smoke. The sensing material is SNO₂ for which the conductivity is lower in clean environments and higher when smoke or flammable gas is present. #commonpartslibrary #sensor #gassensor #integratedcircuit
646 Uses
2 Stars
Arduino Uno Optical Sensor Shield
Arduino Uno Shield for Blue Light Optical Sensor. The circuit generates a 2.1kHz sinusoidal signal to send to LEDs and contains a filtering and amplification circuit to preprocess the signal. Powered by 24V and regulated down to 12V and 5V to power Arduino. #ArduinoUno
493 Uses
2 Stars
Seeed Studio Wio-E5 mini Dev Board
Wio-E5 mini Dev Board builds in and leads out full GPIO of the Wio-E5 STM32WLE5JC LoRa module. Supporting Long Range protocol and global frequency, the Wio-E5 mini is able to achieve a transmission range of up to 10 km in open areas. It supports EU868 and US915, making it suitable for wireless sensor networks and other IoT devices that require battery power, low power consumption and long range.
9 Uses
2 Stars
BLE Door and Window Sensor Module
This project is a BLE door and window sensor design that uses a U-blox BMD-330-A-R for BLE communication, a reed switch as a sensor, a multi-color LED for status display, and is powered by VBAT. There's also a programming interface and reset switch included. #WiFi #BLE #MCU #ReferenceDesign #Module #reusable #module #simple-embedded #ublox #sublayout
26 Uses
2 Stars
KY-040
KY-040 rotary encoder is a device that generates an electrical signal based upon how much the rotary input device (knob) is rotated and the direction it is rotating in. It is a position sensor with a knob and can be used to control stepper or servo motors with precision. #Module #Rotary-Encoder
571 Uses
2 Stars
