Uploading ESP32 Code
where send the code?
Thought for 9 sec
You’ll upload/send the ESP32 code through the USB port on the ESP32 board/module using the Arduino IDE, PlatformIO, or ESP-IDF.
For this project, the usual flow is:
- Connect the ESP32 board to your computer with USB.
- Open the code in Arduino IDE or PlatformIO.
- Select the correct ESP32 board and COM/serial port.
- Click Upload.
- If upload fails, hold the BOOT button while uploading, then release it.
If you mean “where should I put the code in Flux,” then you can add it as a project file/document for reference, but the actual firmware is uploaded to the ESP32 from your computer via USB.
Add USB programming
Add BOOT/EN circuit
Check programming wiring
Save upload steps
![ESP32 Robot Controller | AI Design Review Tutorial [Example] thumbnail](https://img-cdn.flux.ai/eyJidWNrZXQiOiJncmF2aXRvbi1lbGVjdHJpYy1zeW1ib2xzIiwia2V5IjoiZG9jdW1lbnRfYXNzZXRzL1RodW1ibmFpbC1FU1AzMi0tMS0tZTNjNjM0OGEtYjEzMy00YjliLWEyYTItMzY1MGNiMjgyYWJiLnBuZyIsImVkaXRzIjp7InJlc2l6ZSI6eyJ3aWR0aCI6MTM2LCJoZWlnaHQiOjEzNiwiZml0IjoiY29udGFpbiIsImJhY2tncm91bmQiOnsiciI6MCwiZyI6MCwiYiI6MCwiYWxwaGEiOjB9fX0sIm91dHB1dEZvcm1hdCI6IndlYnAifQ==)