This TPS5430DDA-based design is a step-down voltage regulator, converting a higher input voltage to a stable 5V output. Ideal for applications requiring a regulated 5V supply. #referenceDesign #Module #Sublayout #stepDown #voltageRegulator #5V #TPS5430 #TPS5430DDA #reusable #module #powermanagement #texas-instruments #sublayout

This LTC3642-based design is a step-down voltage regulator, converting a higher input voltage to a stable 5V output. Ideal for applications requiring a regulated 5V supply. #referenceDesign #Module #Sublayout #stepDown #voltageRegulator #5V #LTC3642 #LTC3642IMS8E #reusable #module #powermanagement #analogdevices #sublayout

This TPS5430DDA-based design is a step-down voltage regulator, converting a higher input voltage to a stable 5V output. Ideal for applications requiring a regulated 5V supply. #referenceDesign #Module #Sublayout #stepDown #voltageRegulator #5V #TPS5430 #TPS5430DDA #reusable #module #powermanagement #texas-instruments #sublayout

The NE555 devices are precision timing circuits capable of producing accurate time delays or oscillation. In time-delay or monostable operating modes, the timed interval is controlled by a single external resistor and capacitor network. In the astable mode of operation, the frequency and duty cycle are controlled independently with two external resistors and a single external capacitor. Each timer has a trigger level equal to approximately one-third of the supply voltage and a threshold level equal to approximately two-thirds of the supply voltage. These levels can be altered by use of the control voltage pin (CONT). When the trigger input (TRIG) is less than the trigger level, the flip-flop is set and the output goes high. If TRIG is greater than the trigger level and the threshold input (THRES) is greater than the threshold level, the flip-flop is reset and the output is low. The reset input (RESET) overrides all other inputs and is used to initiate a new timing cycle. If RESET is low, the flip-flop is reset and the output is low. Whenever the output is low, a lowimpedance path is provided between the discharge pin (DISCH) and the ground pin (GND). Tie all unused inputs to an appropriate logic level to prevent false triggering. The output circuit is capable of sinking or sourcing current up to 200mA. Operation is specified for supplies of 5V to 15V. With a 5V supply, output levels are compatible with TTL inputs. Features - Timing from microseconds to hours - Astable or monostable operation - Adjustable duty cycle - TTL-compatible output can sink or source up to 200mA - On products compliant to MIL-PRF-38535, all parameters are tested unless otherwise noted. Applications - Pulse-shaping circuits - Missing-pulse detectors - Pulse-width modulators - Pulse-position modulators - Sequential timers - Pulse generators -F requency dividers - Industrial controls

High-Speed CAN Transceiver, 1Mbps, 5V supply, SOIC-8 High-Speed CAN Transceiver SOIC*3.9x4.9mm*P1.27mm*

Single RS232 driver/receiver, 3.0V to 5V supply, 250kb/s, AutoShutdown Plus, SSOP-16 package rs232 uart transceiver SSOP*5.3x6.2mm*P0.65mm*

High-Speed CAN Transceiver, 1Mbps, 5V supply, Vio pin, -40C to +125C, DIP-8 High-Speed CAN Transceiver DIP*W7.62mm*

Single RS232 driver/receiver, 5V supply, 460kb/s rs232 uart transceiver line-driver MSOP*

High-Speed CAN Transceiver, 1Mbps, 5V supply, DIP-8 High-Speed CAN Transceiver DIP*W7.62mm*