An ATtiny13 is more than sufficient to control almost any number of NeoPixels via an IR remote. The NeoController was originally developed as a tester for 800kHz NeoPixel strips. Since there was still so much flash left in the ATtiny13, an IR receiver was integrated so that some parameters can be controlled with an IR remote control. In this way, it is also suitable as a simple and cheap remote-controlled control unit for NeoPixels. Due to its small size (21.6mm x 11.4mm), it can be soldered directly to the LED strip without any problems. The power supply via a USB-C connection enables currents of up to 3A. There is still more than a third of the flash memory left for additional ideas.

NEO-M9N GPS Breakout with on-board chip antenna is a high quality GPS board with equally impressive configuration options. The NEO-M9N module is a 92-channel u-blox M9 engine GNSS receiver, meaning it can receive signals from the GPS, GLONASS, Galileo, and BeiDou constellations witn ~1.5 meter accuracy. This breakout supports concurrent reception of four GNSS. This maximizes position accuracy in challenging conditions, increasing precision and decreases lock time; and thanks to the onboard rechargeable battery, you'll have backup power enabling the GPS to get a hot lock within seconds! Additionally, this u-blox receiver supports I2C (u-blox calls this Display Data Channel) which made it perfect for the Qwiic compatibility so we don't have to use up our precious UART ports. Utilizing our handy Qwiic system, no soldering is required to connect it to the rest of your system. However, we still have broken out 0.1"-spaced pins in case you prefer to use a breadboard.

Welcome to your new project. Imagine what you can build here.

Waterproof ESP32-C6 BLE MTB GPS Computer with NEO-M9N, LiPo Power Management, USB-C, and External SMA Antenna

The neo is an open source robotics research platform. It is powered by a OnePlus 3 smartphone and an STM32F205-based CAN interface board, in a 3d-printed housing with active cooling.

The neo is an open source robotics research platform. It is powered by a OnePlus 3 smartphone and an STM32F205-based CAN interface board, in a 3d-printed housing with active cooling.

controller board for 12-24v led lights, board holds arduino and panel of transistors

Controle de potência AC com SCR TIC106, retificador em ponte, disparo RC com lâmpada neon e bornes THT #SCR #ControleAC #Retificador #DisparoNeon