Wi-Fi Enabled Audio Notification System with Push Button Trigger and Explicit NodeMCU-12E Pin Mapping

ATTiny85 based module decoding commands from an IrDA demodulator and activating a solenoid push pull

Design a schematic using an ESP32-S3 microcontroller that functions as a USB HID gamepad. The system includes two analog joysticks (each with X and Y axes), four normally open push buttons, and one status LED to indicate HID connection. Each joystick has two analog outputs connected to ADC pins. The push buttons connect to digital GPIOs with 10kΩ pull-down resistors. The status LED is connected to a digital GPIO through a 220Ω resistor. Place the ESP32-S3 in the center of the schematic, the joysticks to the left and right, and two buttons above each joystick. The circuit is powered by USB.

This is a motion detector circuit using an ESP32 microcontroller and PIR sensor. It features USB-C connectivity, RGB LED indication, push buttons and is powered by a 3.3V supply. #referenceDesign #edge-computing #edgeComputing #espressif #template #iot #PIR #esp32 #reference-design

This is a motion detector circuit using an ESP32 microcontroller and PIR sensor. It features USB-C connectivity, RGB LED indication, push buttons and is powered by a 3.3V supply. #referenceDesign #edge-computing #edgeComputing #espressif #template #iot #PIR #esp32 #reference-design

Push Button 6mm 7.3mm Square Plunger 50mA Brick nogging 6.3mm SPST 24V SMD,6.3x6x7.3mm Tactile Switch

Control board for autonomous or radio-controlled robots. It has inputs to connect distance sensors and encoders for autonomous mode. It can be radio controlled by the ESP32 bluetooth or by connecting a Flysky RC controller receiver to the IBUS port. It also has 3 push buttons and you can connect some kind of display by I2C to visualize and select configuration modes.

Control board for autonomous or radio-controlled robots. It has inputs to connect distance sensors and encoders for autonomous mode. It can be radio controlled by the ESP32 bluetooth or by connecting a Flysky RC controller receiver to the IBUS port. It also has 3 push buttons and you can connect some kind of display by I2C to visualize and select configuration modes.