8-channel 16-bit simultaneous-sampling USB-C data acquisition board using ESP32-S3-WROOM-1U-N8 and ADS8588S, with ±10 V single-ended analog inputs and separate filtered analog 5 V supply.

Arduino-compatible SMC3/SimTools 3-DOF motion controller for three 12 V worm-drive motors, Hall feedback sensors, dual USB-C interfaces, and E-stop safety input.

ArcBridge by Bridgeway Audio — a Raspberry Pi Pico 2 based HDMI audio embedder/DDC with TOSLINK and coax S/PDIF inputs, HDMI TMDS output with dummy video, ARC return audio, and CEC participation, powered from the Pico USB-C port.

USB-C powered ESP32 WiFi water flow meter for a 3/4 inch PVC pipe using an external 12V RS485 ultrasonic flow sensor, protected power input, 3.3V logic, status LEDs, and programming/reset support.

Ziplink Edge Controller: 12-24 V input controller with PIC32MZ MCU, USB-C service port, WiFi/BLE UART module, QR/NFC UART interfaces, RS-232/RS-485 ports, and three protected low-side load outputs. Imported KiCad source is being evaluated for schematic reconstruction and exact part selection.

Production-intent ESP32-S3 handheld controller with USB-C sink power, ST7789 SPI TFT, 5-way controls, class-D speaker output, and factory test pads on a 4-layer PCB.

Ruggedized battery-powered PeakNode 1 LoRa PWAN node with SX1262 LoRa mesh over SPI, LTE Cat-M1/NB-IoT modem, GNSS, LPCNet-capable audio path, USB-C charging and LiFePO4 power management. Targets a 4-layer 90 mm x 60 mm IPC Class 2 layout with 3.3 V main and 1.8 V I/O rails, dual SMA antennas, two RGB status LEDs, three tactile buttons, low-leakage power architecture for sub-10 uA sleep, and defined RF keep-out zones under the LoRa and LTE antenna regions.

Compact 30 mm x 20 mm 2-layer USB-C to TC2030 programming/debug adapter for ESP32-S3 native USB-Serial/JTAG with CC pull-downs, USB ESD protection, VBUS activity LED, manual reset, and JLCPCB-compatible manufacturing constraints.