This is a LoRa-based door and window sensor incorporating a microcontroller unit (MCU). It features a reed sensor, LED indicators, a AAA non-rechargeable battery, and a booster IC for constant voltage. The MCU is linked to peripherals through nets, ensuring optimal performance #LoRa #MCU #ReferenceDesign #project #referenceDesign #simple-embedded #seeed #seeed-studio #template #reference-design

I'm building an audio amplifier. These are the project requirements: - Type of Amplifier: Class D (for energy efficiency). - Input Source: Line-level input from a standard audio source, e.g., mobile phone or PC. - Output Power: 10W per channel (for a stereo setup). - Number of Channels: 2 (stereo output). - Distortion: Total Harmonic Distortion (THD) of less than 0.1% at full power. - Frequency Response: 20Hz to 20kHz. - Power Supply: Operate from a single 12V DC source. - Protection: Over-current and thermal protection for the amplifier IC. - Connectivity: Standard 3.5mm audio jack for input and screw terminals for speaker outputs. - Volume Control: A physical potentiometer for volume control. - Indicator: An LED indicator that shows power ON status. - Size Constraints: PCB size should not exceed 100mm x 100mm. Consider every requirement individually when answering any question

Running LED circuit that utilizes a 555 clock output and a decade counter. It runs when the push-button is held down and then slowly stops once it is released.

The AAduino is an wireless Arduino clone the size of an AA battery with Keystone battery terminals rotated 180° to act as positive and negative terminals. It is meant to go inside a 3xAA battery holder creating a very small wireless node. Powered by an ATMega328p, it is fitted with an RFM69CW companion, two DS18B20 temperature sensors and an indicator LED

Simulator template for an LED part. Check out the Code editor for instructions!

Simulator template for an LED part. Check out the Code editor for instructions!

Simulator template for an LED part. Check out the Code editor for instructions!

RGBW SMD,5x5mm Light Emitting Diodes (LED) ROHS #LED#Addressable

This is a simulation of controlling an LED using STM32 in Flux!

4x4 LED Matrix, contains 16 LEDs.

Simulator template for an LED part. Check out the Code editor for instructions!

This is a typical transistor key controlled by a button that turns on an LED. The project is with a schematic and 3D simulation

This is a typical transistor key controlled by a button that turns on an LED. The project is with a schematic and 3D simulation

Simulator template for an LED part. Check out the Code editor for instructions!

Simulator template for an LED part. Check out the Code editor for instructions!

Development of LED array driver for medical imaging research. Adjustable intensity, frequency, and LED wavelength. Ramp times <100us.

This is a project with an animation of LED lights on a board created in flux!! #led #js #flux #stm

Simulator template for an LED part. Check out the Code editor for instructions!

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Onboarding example document for new users.

Welcome to your new project. Imagine what you can build here.

A simple fixed linear voltage regulator board that can provide 3.3V up to 1A output and could operate down to 1V input-to-output differential. #firstpcbFlux