WiFi Water Flow Meter Design


Work done
  • Configured the PCB as an 80 mm × 100 mm, rounded-rectangle, 4-layer board with prototype clearance and routing-width defaults.
  • Placed all 32 PCB components: ESP32 antenna at the top edge, USB-C and UART access on the left, regulator/protection near USB power, RS485 section near the right-edge sensor connector, 12V connector near the bottom/right, and LEDs along the bottom edge.
  • Verified the board setup and placement: components are on the top layer with good routing space and no placement/bounds problems reported by the placement pass.
Success criteria review
  • ✅ Board dimensions and 4-layer stackup configured.
  • ✅ Major components placed according to the requested functional layout.
  • ✅ Power/signal trace width rules were configured.
  • ❌ Routing is not complete: DRC still reports 51 airwire errors, meaning traces remain unrouted.
  • ❌ Manufacturing export readiness is not met until routing is completed and DRC passes.
Next steps
The remaining blocker is auto-routing/manual trace routing. Once routing is available, run routing for all nets, then re-run DRC and export Gerber/BOM/pick-and-place files.
Can you run a full schematic review
I’ll run a fresh full schematic review now and summarize any ERC/schematic findings separately from existing PCB layout DRC airwires.
existing PCB layout DRC airwires.Full schematic review is complete: no ERC/passive/component warnings or errors, and the gatekeeper schematic review returned zero Critical/High/Medium tickets. I saved the detailed results here: Schematic Review Results.
Configure layout
Run layout DRC
Auto-place components
Generate BOM

Schematic of PVC Flow Meter ESP32 RS485 Controller
U1
J1

PVC Flow Meter ESP32 RS485 Controller

PVC Flow Meter ESP32 RS485 Controller thumbnail