Temperature and Humidity Sensor Node Design
Thought for 21 sec
I escalated it internally with the stuck job ID and project link.
Practical workaround: fork/duplicate the project and try routing in the copy. The stuck autoroute job is likely attached to this project instance, so a duplicate may clear the blockage without waiting on support.
Recommended steps:
- Open the project menu.
- Choose Duplicate, Fork, or Save a copy.
- Open the copied project.
- Ask me to run DRC/autoroute there.
If the copy still inherits the stuck job, the fallback is to keep the current schematic/layout and manually route the remaining critical nets, but that will be slower than autoroute.
Thought for 6 sec
Yes — use Clone Project. That is the best workaround here.
What to do:
-
Open the current project.
-
Choose Clone Project from the project/menu options.
-
Give the clone a clear name, for example:
Text
Open Hornet 16-Channel 28V Magnetic Hold Driver - Routing Retry -
Open the cloned project.
-
Confirm the schematic/layout copied over.
-
Tell me: “I cloned it, continue routing in the clone.”
Why this should help: the stuck job appears tied to this project’s autoroute job queue. A clone may create a fresh routing/job state while preserving the schematic and PCB layout work.
After cloning, I’ll first run a clean DRC/airwire check in the clone, then retry autorouting there.
Clone and reroute
Review before clone
Manual routing fallback
Explain clone process
Check manufacturing readiness
Waiting for input
