Electrical Verification
Thought for 5 sec
Routing requires Agent mode to inspect the updated PCB, check routing feasibility, route all nets, and verify remaining airwires/DRC.
Thought for 4 sec
Understood: routing only—no component placement or movement. Switch to Agent mode to route the existing placement and verify all airwires and routing DRC.
Continue in Agent Mode
Thought for 9 sec
I’ll preserve the current placement, run a routing feasibility check, route the board, then verify remaining airwires and routing DRC.
Worked for 17 mins 10 sec
Auto-routing converged with the existing placement: all nets are routed. I’m running the final airwire and DRC verification now; no components were moved.
Worked for 46 sec
Board routing completed without moving components.
- 0 airwires
- 0 dangling traces
- No routing-related DRC errors or warnings
- Auto-router noted one skipped decoupling-routing preference on GND, but the net is fully routed and DRC-clean.
Review route quality
Clean up decoupling
Manufacturing readiness
Export fabrication files
