ESP32 S3 MicroSD
Thought for 5 mins 51 sec
Thought for 5 sec
1/4 Inspect current schematic, executor result, and project files
Inspect current schematic, executor result, and project files
Complete or correct USB-C, power, ESP32-S3, and microSD wiring
Run independent connectivity/ERC verification and remediate issues
Finalize project documentation and report results
Thought for 6 sec
Referenced guidance.
Thought for 8 sec — Looking for orchestration tools
Searching executors in /rustyturtle/esp32-s3-usb-c-microsd-board~ee…
Thought for 5 sec
Reading ESP32-S3 USB C Schematic's report…
Thought for 7 sec
Steering ESP32-S3 USB C Schematic…
Thought for 5 sec
Awaiting 1 background task
Received notification from "ESP32-S3 USB C Schematic" that it finished — picking the work back up.
Thought for 4 sec
The executor completed a wiring pass: the project now has 16 nets connecting the 23 existing components, up from zero nets. This confirms schematic connectivity was added during this session.
Still unverified
- Exact USB-C, TPS62162, ESP32-S3, and microSD pin-to-net connectivity
- Final GPIO mapping and card-detect bias
- ERC/design-review status
- Project Specification, power budget, firmware starter, and bring-up-plan files
- Schematic readability and no-connect assignments
I could not retrieve the executor’s final report or perform the required independent review, so the schematic should not yet be considered manufacturing-ready. Execution stopped because your ACUs ran out.
Review schematic connectivity
Check ERC and DRC
Create project documentation
Verify power connections
