Project Start Chat
Thought for 3 sec
Next steps, once ACUs are available:
- Audit the 20 existing components against the specification and remove/replace incorrect parts.
- Complete the schematic BOM: power protection, regulator support parts, relay drivers, light MOSFET/protection, battery ADC divider, ultrasonic interfaces, whisker input, connectors, and test points.
- Wire all nets, including the exact J1/J2 assignments.
- Finalize whisker sensing using the measured states:
WHISKER_Arelative toWHISKER_Bis +5 VDC open and 0 V hit, with galvanic isolation maintained. - Run ERC and independent design review, correcting all actionable faults.
- Verify the TE DTM13-12PC-12PD-R008 footprint orientation, cavity numbering, and mating-face mapping against the official customer drawing.
- Start PCB layout only after schematic approval; then place, route, run DRC, and validate outdoor/high-current constraints.
- Release fabrication files only after connector mapping, whisker bench loading, battery transients, lighting current, and ultrasonic sensor model/pinout are validated.
No project changes were made this turn. Execution cannot resume because your ACUs ran out.
when are my ACUs are available:
Thought for 3 sec
I can’t see your ACU balance or renewal date. Check your Flux account’s usage/billing page for the reset date or purchase options; if it looks incorrect, contact Flux support at https://docs.flux.ai/Introduction/getting-support.
No project changes were made, and execution remains stopped because your ACUs ran out.
can you do anything
Thought for 2 sec
I can still help with text-only engineering guidance, such as reviewing requirements you paste here, planning tests, explaining circuits, or preparing measurement procedures.
I cannot inspect, edit, wire, or verify the Flux project until ACUs are available. The last confirmed state remains 20 components and 0 nets; execution stopped because your ACUs ran out.
