Update Pad Specifications and Route Traces
Change VIN and V- pads to through holes. Also fix all of the Airwires
Thought for 4 sec
I’ll update the VIN and V− pads to through-hole footprints, then inspect and route the remaining airwires and verify the result.
Worked for 41 sec
I found J1 pin 1 is VIN and J2 pin 1 is V−/VNEG; I’m applying explicit through-hole pad rules to those two pads, then I’ll rerun routing.
Worked for 1 min 17 sec
The two power pads now have explicit through-hole settings. The router check flagged congestion, so I’m going to spread the crowded center components slightly before routing.
Worked for 5 mins 17 sec
Done: J1 Pin 1 (VIN) and J2 Pin 1 (V−/VNEG) are now explicit through-hole pads, and auto-routing completed successfully with 94 routing nodes added.
Open items:
- Airwire check now reports no open/error/warning airwires.
Suggested next steps:
- Run a full DRC/ERC pass.
- Review routed trace paths around U1 and the trimmers.
- Export manufacturing files when ready.
Run checks and export
Run full DRC/ERC
Review critical routing
Check manufacturability
Export fab files
