USB-C Sensor Node
Worked for 4 mins 29 sec
Implemented the schematic for the USB-C powered Wi‑Fi/BLE temperature/humidity node. It uses a SiWG917 Wi‑Fi/BLE 5.4 module, SHT41 T/RH sensor, USB-C sink input, TPS25940 true reverse-blocking eFuse with OVP/UVLO/OCP/soft-start, MP28301 3.3 V buck regulator, ESD protection, reset/ISP/SWD debug, I2C pull-ups, and status LED.
Created project files:
Open items:
- PCB layout/routing is not done yet, so airwire DRC errors are expected.
- Generic passives still need final manufacturer MPNs before manufacturing export.
- Layout must enforce the SiWG917 antenna keepout and thermal isolation around the SHT41.
Suggested next steps:
- Set board size/stackup and move into PCB placement.
- Place U1 at the board edge with antenna keepout and U4 away from heat sources.
- Route power, buck, I2C, SWD/UART, and USB-C protection paths.
- Assign final passive MPNs and run full DRC/manufacturing checks.
komponen pada layout belum ada jalur pcb nya
Thought for 3 sec
Benar—komponen sudah ditempatkan, tetapi jalur PCB belum dirouting sehingga airwire masih terlihat. Saya belum dapat menjalankan autorouting sekarang karena ACUs akun sedang tidak tersedia; tahap tersisa adalah menetapkan aturan lebar jalur/clearance, membuat breakout USB‑C D+/D−, merouting daya 5 V/3,3 V dan sinyal, menjaga keepout antena SiWG917, lalu menjalankan DRC hingga bersih.
Atur aturan routing
Rute USB dan daya
Jaga area antena
