ESP32 SD Card Board

Worked for 53 sec

Thought for 18 sec — Choosing components for low-power MCU

Found 3 results for Find Flux library USB input eFuse or protection switch IC for 5 V USB-C sink with adjustable/current limit around 0.75 to 1 A, overvoltage protection threshold above normal USB 5.25 V and below 9 V, undervoltage lockout, reverse current blocking, soft-start/inrush control, active SMD part. Prefer TI TPS2595 TPS2596 TPS2594 AP2265 AP22802 style eFuse..

Found 10 results for TPS2595.

Found 10 results for TPS2596.

Found 2 results for AP22652.

Found 4 results for NCP361.

Thought for 19 sec

Thought for 16 sec

Reading SIWG917Y111MGABAR, SHT41-AD1B-R2, USB4105-GF-A, TPS259621DDAR, MP28301GG-Z, USBLC6-2SC6, ESD5341N datasheets.

Thought for a moment

Assessing developer requirements

I need to follow the developer's instructions exactly. However, it seems the results are missing the pinout or footprint, which likely means the drawing isn't capturing the details properly—it's probably not using OCR. I should search more thoroughly to find information about GF-A. It's clear that I need to dig deeper to ensure I get the right information and meet the requirements correctly. Let's stay focused on that!

ridanjiwane

can u make a esp32 wroom32E connected to a sd card module and pads for display module for vcc gnd cs reset a0 sda sck and led, and with inbuilt charging module assume 800 mah battery and voltage given to esp32 should be constant so its bluetooth doesnt become unstable and also do a pcb antenna also include pads for battery and a small slide switch for power and pads for 5 buttons

Thought for 9 sec

flux

No design changes were made this session; the project remains empty with 0 components and 0 nets.

Requested work still pending: ESP32-WROOM-32E, microSD interface, display pads, regulated battery power and charging for an 800 mAh cell, battery pads, slide power switch, five button pads, and antenna/layout provisions. Note that ESP32-WROOM-32E already contains a PCB antenna, so the PCB should use the module’s antenna keepout rather than adding a second antenna.

Execution stopped because your ACUs ran out.

Waiting for input

No schematic yet

Talk to Flux to get started.