USB-C Sensor Schematic
Start a new project
Thought for 4 sec
No design changes were made in this session. The project already contains a partial USB-C Wi‑Fi/BLE temperature-humidity sensor schematic; remaining work is to review connectivity, restore/select the MCU, validate power and protection circuits, then complete PCB layout.
Execution is currently unavailable because the account has no ACUs. Once ACUs are available, we can resume from the existing schematic.
Start Auto-Layout
Thought for 2 sec
I couldn’t analyze or modify the PCB because the account currently has no available ACUs, so no auto-layout was run and no results were applied.
Remaining work once ACUs are available:
- Inspect current placement, airwires, routing, board outline, and DRC state.
- Re-place components only where needed.
- Route remaining connections.
- Verify overlaps, antenna/thermal constraints, clearances, and unresolved airwires.
Check placement status
Auto-place components
Route remaining nets
Review DRC results
Optimize layout first
Waiting for input
