Sign Language Translation Glove Design
suggest what you think is right and consider that only
Thought for 2 mins 40 sec
Here are my recommendations, based on your schematic and wearable constraints:
Table
| Part | Description | Link |
|---|---|---|
| ESP32-WROVER-IE-N8R8 | Dual-core Wi-Fi/Bluetooth MCU module with 8 MB PSRAM + 4 MB flash; 38 pins, WROOM footprint | ESP32-WROVER-IE-N8R8 |
| 10 kΩ Resistor (0603) | ±1% pull-up resistor for each flex sensor divider (5× needed) | 10 kΩ 0603 Resistor |
| Flex Sensor 2.2″ | Bourns-style resistive flex sensor, ~10 kΩ nominal, for finger-bend detection (5× needed) | 3382G-1-103G |
| MPU-6050 IMU Module | GY-521 style breakout with I²C pull-ups, 3.3 V-powered accel + gyro for motion/orientation sensing | MPU-6050 Module |
| DC Barrel Jack (2.1 mm) | Through-hole right-angle jack for 12 V input; fits standard power adapter for glove electronics | PJ-051AH |
Next, shall I add these components into your schematic?
Add ESP32 module
Add pull-up resistors
Add flex sensors
Add IMU breakout
Add barrel jack
priya28
priya28
Image