I’ll preflight the board for routing readiness, start the autoroute if it passes, then review the routed board for remaining issues.

Preflight passed, with warnings for a few blocked pins and overlapping same-net connector pins. I’m starting autoroute now; the blocked pins may remain unrouted afterward.

Autoroute could not start because there’s already an active auto-layout job on this project with status outOfCredit.

Preflight did pass, but it reported likely routing issues on USER_BUTTON, UWB_SPI_CS, and UWB_SPI_MOSI due to blocked pins. To continue, discard or resolve the existing auto-layout job, then I can start the new autoroute.

I’ll retry the autoroute now that the previous job was discarded, then I’ll check the result for remaining routing issues.

Retry still failed: the same auto-layout job is still blocking routing with status outOfCredit.

Board readiness check passes, but the autorouter won’t start until job auto-layout-94801d1c-2912-4886-839c-4ea71b110296 is fully cleared/discarded. Also note: preflight still warns that USER_BUTTON has a blocked pin and may remain unrouted even after autoroute starts.