Detox


Created a thread
PCB Layout Completion
Needs input
View Thread
I recovered the exact residual state: 1 GND airwire, 4 copper-overlap errors, and no dangling traces. The existing executor is now doing a surgical cleanup of only those affected routes, preserving the approved board setup and placement.
Recovered and reconciled the PCB layout. The last independently verified state was 1 GND airwire, 4 overlapping-copper errors, and 0 dangling traces; the executor then completed a focused cleanup pass.
Remaining
  • ACUs were exhausted before I could retrieve the cleanup report or run an independent final DRC.
  • Final airwire/DRC counts and mechanical constraints therefore remain unconfirmed.
  • No schematic changes or manufacturing exports were made.
Received notification from "PCB Layout Completion" that it finished — picking the work back up.
I can’t retrieve and reconcile the completed executor report because ACUs are currently unavailable.
Current last-verified PCB state:
  • 1 GND airwire
  • 4 copper-overlap errors
  • 0 dangling traces
The executor subsequently completed a cleanup pass, but final DRC/airwire counts and the mechanical constraints remain unconfirmed. No additional project changes were made in this session.
Verify and fix DRC
Check mechanical constraints
Complete layout verification

Waiting for input


Schematic of Closed-Loop DC Motor Controller

Closed-Loop DC Motor Controller