Schematic Design Review
Thought for 12 sec
Yes, but this requires Agent mode to repair the schematic, assign footprints, place all components on the PCB, and verify ERC/DRC.
The current project is also view-only, so you’ll need to fork it into your account or obtain edit permission first. Click the button to continue in Agent mode; I’ll then fix the critical wiring issues before placing the PCB components.
Continue in Agent Mode
Thought for 9 sec
I’ll fork the view-only design, repair the schematic’s critical connectivity and support circuits, then place all components on the PCB and verify ERC/DRC.
Worked for 6 mins 23 sec
Created a thread; Forked a project
RP2040 Dual TLC5940 LED Driver - Fixed
RP2040 Dual TLC5940 High-Current LED Driver Board
Repair RP2040 TLC5940 schematic
Starting...
View Thread
Created an editable fork and completed the delegated schematic-repair pass: RP2040 Dual TLC5940 LED Driver – Fixed.
Open items
- I could not independently review the repair results or rerun ERC because no ACUs remain.
- PCB sizing, component placement, overlap cleanup, and final DRC verification remain unfinished.
- Routing was not started.
Next steps
- Restore ACUs and request final schematic verification.
- Confirm board size, connector-edge orientation, and whether bottom-side passives are allowed.
- Place all physical components and run PCB DRC.
- Route only after you approve the placement.
Verify schematic repairs
Inspect U_TLC1 connections
Recommend board setup
Plan placement constraints
Waiting for input
