PCB-First vs Enclosure-First Design


Briefly describe what it's like to design a complete product in Flux. Help me understand what the PCB-first and enclosure-first design workflows are like to work with.
Designing a complete product in Flux means working through the electronics, PCB, enclosure, and how they fit together—not just drawing a circuit.
  • PCB-first: Start with the circuit, then place and route the board. Shape the enclosure around its connectors, mounting holes, and cooling needs. This suits products where electronics drive the design, but can constrain the final appearance.
  • Enclosure-first: Start with the product’s shape, size, controls, and connector access. Design the PCB to fit that space. This suits handheld or space-constrained products, but may require more placement compromises or multiple boards.
Both workflows involve iteration: check fit, electrical performance, heat, and manufacturability together before ordering. Your project is unchanged; this was an overview only. Further execution is stopped because your account has run out of ACUs.

Waiting for input


Schematic of ESP32 x86 PC | Advanced [Example]
ESP1
VGA
C11
Capacitance
0.1uF
R1
Resistance
10kΩ
TX
RESET
EN
GND
R12
Resistance
10kΩ
R14
Resistance
10kΩ
BOOT
IO0

ESP32 x86 PC | Advanced [Example]