No PCB analysis, placement, or routing changes were performed, so the project remains unchanged from its current state. The remaining work is to inspect the board for placement quality and airwires, then run component placement, routing, or both as indicated, followed by DRC/routing verification.

Execution stopped because your ACUs ran out.

No analysis or auto-layout was executed, and the PCB remains unchanged. Placement/routing inspection, any required component repositioning, autorouting, and final DRC verification are still pending.

Execution stopped because your ACUs ran out.

The PCB was not analyzed or modified. Auto-placement, autorouting, and post-layout verification remain pending; the project is unchanged.

Execution stopped because your ACUs ran out.