// Howdy 👋.
//
// This is where you can create powerful part automations like resistors that tell you when too much current is flowing through them
// You can also create your own flexible parts, like generics (https://docs.flux.ai/Introduction/generic-parts)
//
// If you are new to writing code in Flux make sure to check out our get started docs: https://docs.flux.ai/reference/introduction
//
// We also have a Flux Slack Community in case you need help: https://join.slack.com/t/fluxcommunity/shared_invite/zt-p48n941f-wzQ06kGmuFJ2HXnGYT1JkA
//
// To infinity and beyond 🚀
#define LED_D4 D4
#define LED_D6 D8
void setup() {
// Set D4 and D6 as output pins
pinMode(LED_D4, OUTPUT);
pinMode(LED_D6, OUTPUT);
}
void loop() {
// Turn on D4, wait for a moment, then turn it off
digitalWrite(LED_D4, HIGH);
delay(500); // Adjust the delay time as needed