Below is a summary of the corrected wiring steps for your schematic using through-hole components:
-
Battery and Push Button:
- Connect the positive terminal of the battery (BAT1) to one terminal of the push button (SW1).
- Use a designated push-button output contact (for example, pin A1 of SW1) to send the signal onward.
-
Resistor Connection:
- Wire the chosen through-hole 1/4 watt resistor (R2) in series with the push button output:
- Connect SW1 pin A1 to one resistor terminal (R2: P1).
- The resistor’s other terminal (R2: P2) will be used to feed the LED.
-
LED Connection:
-
Battery Negative:
This arrangement makes sure that when the push button is pressed, the battery positive is applied, through the push button and resistor, to the LED’s anode. The LED then completes its circuit by returning to ground via its cathode.
You can use the "Apply changes" button to update your schematic with these corrected wiring connections.