Getting Started with Your Project


Proceed now in Agent mode with the connector test board exactly as specified above. No routing or auto-layout.
I’ll build the board exactly as specified, then check the six pin-to-pin nets, header alignment, and four-layer stackup. I won’t run auto-layout or routing, or add zones, Preferred Layers rules, traces, or vias.
Thought for 9 mins 45 sec
Thought for 7 sec
Created 2 tasks.
1/2 Build the two-header circuit and exact unrouted PCB configuration.

Build the two-header circuit and exact unrouted PCB configuration.

Verify component count, connectivity, geometry, stackup, and absence of routing.

Thought for 14 sec
Awaiting 1 task
"Connector Test Board Setup" completed.
The headers and board setup are in place, with no routed copper. I’m checking the exact pin coordinates, net mapping, and layer settings against your requirements.
Thought for 1 min 51 sec
Thought for 8 sec
Awaiting 1 task
"PL-QA Board Verification" completed.
Thought for 16 sec
Thought for 6 sec
Managing 1 task
Thought for a moment

Flux stopped


Schematic of PL-QA forced-choice test board
J2
J1

PL-QA forced-choice test board