Fabrication Readiness


Verification is only partially complete:
J12 exact pinout
  1. 5 V
  2. GND
  3. I²C SCL
  4. I²C SDA
  5. ESP32 TX — GPIO9, connect to display RX
  6. ESP32 RX — GPIO10, connect to display TX
  7. 3.3 V
  8. HMI enable/spare — GPIO14
Power
The 5 V source is the DFRobot DFR0379 LM2596 buck module, but the project does not identify the 7-inch display or its maximum current. Therefore, available current margin cannot yet be confirmed safely.
Connector and clearance
J12 is a vertical Samtec SSW-108-02-G-S 2.54 mm female socket, not a locking cable connector. It is approximately 21.35 × 3.55 mm and located inside the board rather than at an edge. The vertical mating direction is clear, but exact cable/plug clearance cannot be validated without the mating connector housing and cable exit direction.
Please provide the 7-inch display model/MPN or product link and the intended mating cable/connector. Those two items are required for an exact current and mechanical-clearance verdict.
myy pcb size
Your PCB size is 160 mm × 185 mm.
  • Area: 29,600 mm²
  • Approximate imperial size: 6.30 × 7.28 inches
  • Stackup: 4 layers
  • Board thickness: approximately 1.30 mm
Check exact J12 pinout
Size 5V rail margin
Check connector clearance
Cross-check display power

Waiting for input


Board Bring-Up Plan
  1. With no modules connected, apply 12V to J1 and verify LM2596 output is adjusted to 5.0V before connecting the ESP32 DevKit.
  2. Verify common GND continuity across J1, U2, U1, sensor headers, relay modules, buzzer, OLED, MLX90640, and ESP32-CAM.
  3. Power the ESP32 DevKit from the 5V rail and confirm its 3V3 rail is present.
  4. Test I2C bus scan on GPIO21/GPIO22 before loading MLX90640 and OLED application firmware.
  5. Validate each GPIO one at a time: MQ-2 AO on GPIO34, DHT11 on GPIO4, flame DO on GPIO35, DS18B20 on GPIO32, relay outputs GPIO26/GPIO25, and buzzer GPIO27.
  6. Confirm MQ-2 AO voltage never exceeds 3.3V at GPIO34; add a divider or level shifting if the module outputs 5V.
  7. Treat ESP32-CAM UART RX as optional until a DevKit symbol or board connection exposing GPIO0 is selected.