Fabrication Readiness
Thought for 1 min 18 sec
Verification is only partially complete:
J12 exact pinout
- 5 V
- GND
- I²C SCL
- I²C SDA
- ESP32 TX — GPIO9, connect to display RX
- ESP32 RX — GPIO10, connect to display TX
- 3.3 V
- HMI enable/spare — GPIO14
The 5 V source is the DFRobot
Connector and clearance
DFR0379 LM2596 buck module, but the project does not identify the 7-inch display or its maximum current. Therefore, available current margin cannot yet be confirmed safely.J12 is a vertical Samtec
SSW-108-02-G-S 2.54 mm female socket, not a locking cable connector. It is approximately 21.35 × 3.55 mm and located inside the board rather than at an edge. The vertical mating direction is clear, but exact cable/plug clearance cannot be validated without the mating connector housing and cable exit direction.Please provide the 7-inch display model/MPN or product link and the intended mating cable/connector. Those two items are required for an exact current and mechanical-clearance verdict.
Thought for 6 sec
Your PCB size is 160 mm × 185 mm.
- Area: 29,600 mm²
- Approximate imperial size: 6.30 × 7.28 inches
- Stackup: 4 layers
- Board thickness: approximately 1.30 mm
Check exact J12 pinout
Size 5V rail margin
Check connector clearance
Cross-check display power
Waiting for input
