Chat

How can I help you?
Sign up to send

Files

Schematic

Layout

3D View

I want to store my environmental data on this SD card, can you connect it to U1 ...
M

markwuflux

@copilot I want to store my environmental data on this SD card, can you connect it to U1 for me?
3y

copilot

Sure, you can connect the SD card (J1) to the ATTINY841 (U1) using the SPI interface. Here's how you should connect the pins:
  1. Connect J1:MOSI to U1:PA6-MOSI-default
  2. Connect J1:MISO to U1:PA5-MISO-default
  3. Connect J1:SCK to U1:PA4-SCK-default
  4. Connect J1:CS (Chip Select) to U1:PA3 (or any other available GPIO pin, but you'll need to configure it as an output and control it in your firmware)
Don't forget to connect the power supply and ground to the SD card as well:
  1. Connect J1:VCC to the 3.3V power supply
  2. Connect J1:GND to the ground
After connecting these pins, you'll need to update your firmware to handle the SD card communication and data storage. You can use the FatFs library or an equivalent library to handle the file system on the SD card.
3y
3
can you connect U1 and U2?
M

markwuflux

@copilot can you connect U1 and U2?
3y

copilot

Sure, I can help you connect U1 (ATTINY841-SSU) to U2 (BME280) using an SPI interface. Here's the pin-to-pin connection:
  1. U1:PA6-MOSI-default -> U2:MOSI
  2. U1:PA5-MISO-default -> U2:MISO
  3. U1:PA4-SCK-default -> U2:SCK
  4. U1:PA7-SS-default -> U2:CSB
UPDATED PROJECT NETLIST:
Net 0 connects 3.3V:P1, 3.3V:P1, U2:VDDIO, U2:VDD, C2:P1, C1:P2, U1:VCC
Net 1 connects C2:P2, U2:GND, U1:GND, C1:P1
Net 2 connects U1:PA6-MOSI-default, U2:MOSI
Net 3 connects U1:PA5-MISO-default, U2:MISO
Net 4 connects U1:PA4-SCK-default, U2:SCK
Net 5 connects U1:PA7-SS-default, U2:CSB
3y
2
Click on these bubble comments to see copilot in action!
M

markwuflux

Click on these bubble comments to see copilot in action!
3y
4
U2
J1

Environmental Data Logger Copilot V2 Example Project