# Arduino Nano Barebones - SMD No Header (Component) ## Description Important Note: You must connect your own SPI/ICSP programming header if you want to burn the Arduino bootloader to the MCU. In this version, you must also provide your own UART interface. SMD Manufacturing: Need a hotplate and solderpaste Good to haves: - Oscillator Decoupling Caps Expose UART via connector Programming Button Onboard LED Reset Button You don't have to populate everything! Only these are mandatory: Reset Button Find the reference schematic here: https://www.arduino.cc/en/uploads/Main/ArduinoNano30Schematic.pdf ## Component Details - **Owner:** markwuflux - **Created:** 8/11/2023 - **Last Updated:** 10/27/2023 - **Visibility:** Public - **Used in:** 76 projects - **Stars:** 1 - **Forks:** 1 - **Mount Type:** Surface Mount - **Package / Case Code:** SMD - **Pin Count:** 26 ## Pins | Pin | Name | Type | |-----|------|------| | - | 5VTerminal | | | - | A0 | | | - | A1 | | | - | A2 | | | - | A3 | | | - | A4 | | | - | A5 | | | - | A6 | | | - | A7 | | | - | AREF | | | - | D0_RX | | | - | D1_TX | | | - | D10 | | | - | D11_COPI | | | - | D12_CIPO | | | - | D13_CLK | | | - | D2 | | | - | D3 | | | - | D4 | | | - | D5 | | | - | D6 | | | - | D7 | | | - | D8 | | | - | D9 | | | - | GNDTERMINAL | | | - | MCU_RESET | | --- *Generated from [https://www.flux.ai/markwuflux/arduino-nano-barebones-smd-no-header~wd](https://www.flux.ai/markwuflux/arduino-nano-barebones-smd-no-header~wd)*