Predictive Maintenance Device

Yes, finalize interfaces, select components, calculate the power budget, and build the carrier schematic.

Thought for 7 sec

I’ll freeze the modular interface standard, select the carrier components, calculate the verified power budget, build and wire the complete carrier schematic, then run connectivity/ERC checks and resolve concrete issues.

Worked for 2 mins 4 sec

Created a project doc

Block Diagram

View Document

Block Diagram Carrier Architecture Functional Groups and Sourcing Gate Inter-block Nets

Power: 24V_RAW, 24V_PROT, FIELD24V_S1..S4, 5V, MODEM_VBAT, 3V3, GND, ISO_5V, ISO_GND.

Buses: I2C_SDA/SCL, SPI_SCK/MOSI/MISO, per-slot SLOTn_CS/INT/EN, CELL_TX/RX, RS485_TX/RX/DE, USB_D+/D-.

flux

Execution is blocked because the account has no available ACUs. The universal POC/MVP requirements and modular architecture are documented, but no schematic components or nets were added.

Remaining work:

Finalize component selections and module connector pinout
Calculate the datasheet-based power budget
Build and wire the carrier schematic
Run ERC/connectivity verification
Create firmware starter and board bring-up files

Add ACUs to resume from this exact scope.

Add ACUs

Estimate ACU needs

Review documented requirements

No schematic yet

Talk to Flux to get started.