Healer+ Security toolkit -cyber-deck
Worked for 1 min 44 sec
For 5 assembled prototype PCBs with ENIG finish and through-hole assembly:
Table
| Builder | PCB + assembly | Shipping | Delivered total | Per PCB |
|---|---|---|---|---|
| JLCPCB | $72.50 | $10.41 standard / $27.06 UPS | $82.91–$99.56 | $16.58–$19.91 |
| PCBWay | $261.18 | $5–$20 | $266.18–$281.18 | $53.24–$56.24 |
Allow approximately $150–$300 per finished handheld, once you include:
- Display, batteries, keyboard and antenna hardware
- Enclosure, captive fasteners and internal storage
- Unavailable/substituted BOM parts
- Wiring, final mechanical assembly and testing
This excludes engineering time, certification and production tooling.
Recommended build route
- JLCPCB — PCB fabrication and assembly; currently the best-value option.
- JLC3DP or PCBWay 3D — rugged prototype enclosure.
- Local/manual integration — batteries, antennas, display, keyboard, switches and enclosure assembly.
The current PCB layout is not yet manufacturing-ready, so these are budgeting quotes—not an order recommendation yet. Placement, routing, DRC, BOM availability and mechanical fit must be completed before purchasing.
Thought for 38 sec
I’m closing the remaining manufacturing gates now: live layout audit, placement, routing, final DRC/ERC, and fabrication package if the board reaches a clean state.
Worked for 13 mins 26 sec
Thought for 12 sec
Getting a layout overview.
Thought for 11 sec
Completed design checks — found 976 issues.
Thought for 18 sec — Figuring out placement details
Awaiting 1 task
"PCB Placement Done" completed.
Thought for 4 sec
Placement advanced substantially: all 245 components are now inside the 160 × 100 mm board, 37 overlaps were cleared, and all three switching-regulator stages pass their required placement checks.
Remaining work
- Resolve 3 component overlaps.
- Repair U1’s self-intersecting antenna keepout.
- Review the microSD edge-offset warning and three L4 pad-access advisories.
- Generate neckdowns and protected USB-C breakout.
- Route the PCB and run final DRC/ERC.
- Export Gerbers, BOM, and pick-and-place files only after DRC is clean.
Execution stopped because your ACUs ran out.
