Minecraft Lantern PCB
Worked for 3 mins 6 sec
Created a project doc
I selected the main parts and recorded
Thought for 24 sec
I selected the main parts and recorded the power budget/charger settings in Design Notes. Next I’m adding the schematic components and wiring the charger, battery switch, and LED branches.
Worked for 8 mins 7 sec
Blocked because your account currently has no available ACUs, so AI execution is paused.
Accomplished so far: I created the project spec, design notes/power budget, set project metadata, added the USB-C rechargeable 1S LiPo charger architecture, and wired the main schematic blocks: TP4056 charger, USB-C CC pull-downs, JST battery connector, on/off switch, 6 warm-white LEDs with 330Ω resistors, bypass capacitors, and M2 mounting holes. See Project Specification and Design Notes.
Open items:
- Run schematic ERC/design review and clean remaining issues.
- Improve schematic visual placement/wire geometry.
- Create the ≤60×60 mm PCB layout, place/rout components, add labels, and run DRC.
- Generate Gerbers/BOM/pick-and-place after checks pass.
Suggested next steps once ACUs are available:
- Resume with schematic review and cleanup.
- Proceed to PCB placement for the 60×60 mm board.
- Route the board and run DRC.
- Export manufacturing files.
Check ERC issues
Place PCB components
Clean schematic layout
Add silkscreen labels
Export manufacturing files
