YesMan Schematic Design Discussion
Thought for 3 sec
I’ll create the full YesMan schematic draft only: source parts, build the labeled functional blocks, add documentation notes/tables, then run an electrical review and summarize the human-verification items.
Thought for 45 sec
Core parts are available in the library, including the exact ESP32-S3-WROOM-1-N8R2, MCP73871, TPS63031, ICS-43434, USB-C receptacle, USB ESD device, and SP3T slide switch. I’m adding the schematic blocks now with conservative first-draft support passives and verification notes.
Worked for 9 mins 34 sec
Created the YesMan schematic draft in the project and renamed the project to YesMan. I added the ESP32-S3-WROOM-1-N8R2, USB-C/native USB path, LiPo charger/power-path, buck-boost supply, display FPC, ICS-43434 microphone, buttons/mode switch, independent buzzer/motor drivers, connectors, test pads, named nets, and review documentation.
Open items:
- This is a first engineering draft, not production-ready.
- MCP73871 configuration pins and TPS63031 component values/topology still need datasheet-level human verification.
- Display FPC orientation and backlight driver topology must be verified against the actual WH-N133-2424THBIG26-A8 cable/module.
- PCB layout was not started.
Suggested next steps:
- Review the detailed file:
yesman-schematic-draft-review. - Review firmware/compliance notes:
yesman-firmware-and-compliance-notes. - Ask me to do a second-pass datasheet cleanup for MCP73871/TPS63031/display backlight.
- After schematic sign-off, ask me to start PCB placement with antenna, microphone, USB, and regulator constraints.
Datasheet cleanup
Fix charger warnings
Run full review
Verify GPIO choices
Prepare for layout
