Piso WiFi Controller Schematic Design
Thought for 34 sec
I couldn’t find relevant Flux documentation for automatically placing all components inside the board outline, grouping them by functional block, keeping connectors at the edges, and then rerunning auto layout. This probably means that capability is not currently available in Flux documentation.
- Flux Documentation
- [Documentation Search Results](https://docs.flux.ai/?s=component placement auto layout board edges)
- Flux User Community
Route all remaining airwires and complete PCB routing.
Thought for 18 sec
I attempted full PCB routing, but the auto-router is currently unavailable, so I could not complete the remaining airwires.
- Routing pass started with net-type prioritization enabled
- Power nets were recognized correctly:
- VIN_12V_RAW
- VIN_12V_FUSED
- VIN_12V_PROT
- 5V
- 3V3
- GND
- No specific failed nets were reported before the router became unavailable
If you want, I can still help by:
- inspecting the board and listing the remaining unrouted nets
- tightening layout/routing rules further before you retry auto-layout
- exporting the current PCB state for review
Check remaining airwires
Inspect D4 area
Review missing footprints
