Board Design and Power Management
Thought for 4 sec
I can’t execute placement or wiring right now because AI actions are unavailable due to no available ACUs, and I also only have view access to this project.
Nothing has been changed in the project yet. Remaining work:
- Add TP5100 2A charger, 5V buck converter, and 3.3V LDO regulator.
- Add battery input connection to TP5100.
- Route charger/battery output to the 5V buck and 3.3V LDO as appropriate.
- Add decoupling near each rail: 100 µF tantalum + 0.1 µF ceramic in parallel on 5V and 3.3V.
- Verify charger topology, regulator input/output ratings, capacitor voltage ratings, and clean power-net naming.
Once ACUs are available and edit access is granted, I can place and wire this minimal power section directly.
Thought for 3 sec
I can’t open or inspect the attached text file right now because AI actions are unavailable due to no available ACUs, and I still only have view access to the project.
Current project state from this session:
- No components have been added.
- No wiring, placement, routing, or documentation has been changed.
- The requested power section remains to be implemented: TP5100 charger, 5V buck, 3.3V LDO, battery input, and rail decoupling.
When ACUs are available and edit access is granted, I can review the pasted file first, then build the clean minimal power setup accordingly.
Review pasted file
Check permissions
Find power parts
Document power architecture
No schematic yet
Talk to Flux to get started.
