Digital Pet PCB Design
Create a pcb for a digital pet with face animations. The project should include a xiao esp32 s3 development board, an LSM6DSL accelerometer, NT3H2111WOFHKH nfc, DRV2605LDGS haptic motor, pct2075D temperature sensor, and lastly a 7 pin connector for my spi tft round lcd screen module
Thought for 1 sec
I can’t execute design changes right now because AI actions require available ACUs, and this account currently has none available.
What’s accomplished so far:
- No schematic or PCB changes have been made.
- The project is still empty: 0 components, 0 nets.
- Your requested design intent is clear: a digital pet PCB using:
- XIAO ESP32-S3 development board
- LSM6DSL accelerometer / IMU
- NT3H2111W0FHKH NFC tag
- DRV2605L haptic motor driver
- PCT2075D temperature sensor
- 7-pin SPI TFT round LCD connector
What remains to be done once ACUs are available:
- Create the project specification.
- Add and wire the components.
- Define I2C/SPI/GPIO pin mapping for the XIAO ESP32-S3.
- Add pull-ups, decoupling capacitors, NFC antenna connections, haptic motor connector, and LCD connector.
- Run ERC/design review.
- Create PCB placement and routing.
- Prepare bring-up notes and firmware pin map.
A key clarification needed before schematic capture: please provide the 7-pin LCD connector pinout/order for your round SPI TFT module, since these modules vary by vendor.
Provide LCD pinout
Create project spec
Map MCU pins
Find library parts
No schematic yet
Talk to Flux to get started.
No layout yet
When components get added to the schematic, they'll show up here.