Industrial PLC Controller Design
Thought for 3 sec
The final power/isolation closure executor completed, but I could not retrieve and reconcile its report before tool access ended.
Last independently known state:
- 0 airwires
- 0 dangling traces
- Full DRC previously clean
- Four intentional same-net pad overlaps on PS2 accepted
- High-current routes were still largely 0.25 mm
- Explicit all-layer verification of the ≥6 mm isolation corridors remained pending
Therefore, manufacturing readiness is not yet confirmed. The executor’s latest changes still need to be inspected, followed by fresh DRC, connectivity, high-current copper, and all-layer isolation checks. Execution stopped because your ACUs ran out.
Continue
Thought for 2 sec
No additional project work could be performed in this turn because tool access is unavailable.
The PCB still requires reconciliation of the latest remediation report, followed by fresh DRC/connectivity checks, verification that 0.5 A channel and 3 A aggregate paths have adequate copper, and confirmation of ≥6 mm copper-free isolation corridors on every layer. Manufacturing readiness is not yet confirmed.
Execution stopped because your ACUs ran out.
continue
Thought for 2 sec
No project changes or verification could be performed in this turn. The PCB remains pending final DRC/connectivity, high-current copper-width, and all-layer ≥6 mm isolation-corridor verification; manufacturing readiness is not confirmed.
Execution stopped because your ACUs ran out.
