Project Start Conversation
Thought
Created a thread
1.8T Knock Conditioner
Starting...
View Thread
The original builder had not made any project changes before stopping. I’ve resumed it on the same scope; it is still working through component selection and schematic construction.
Thought
The stopped schematic builder was successfully resumed and has now completed its run. I could not inspect or independently verify its finished schematic because the account ran out of available ACUs immediately afterward.
Remaining work:
- Review the builder’s completion report and schematic.
- Run an independent ERC/connectivity check.
- Verify filter response, output limits, power consumption, and RPM-input assumptions.
- Resolve any findings before starting PCB layout.
Received notification from "1.8T Knock Conditioner" that it finished — picking the work back up.
Thought
The executor reports the dual-channel knock-conditioner schematic is complete, but I cannot reconcile or independently verify it because no ACUs are currently available.
Remaining work:
- Inspect the completed schematic and executor report.
- Run ERC/connectivity checks.
- Verify the ~6.9 kHz filtering, 0.5–4.5 V output clamp, RPM compensation, and 5 V power budget.
- Correct any issues before PCB placement and routing.
Inspect schematic issues
Verify circuit performance
Document design targets
Waiting for input
