Project Starter


PCB component placement is complete on a preliminary 100 × 100 mm, 4-layer board. P4 faces left, USB-C faces down, microSD ejects right, OLED is along the lower/front edge, ESP32 antenna overhangs the top edge, and ADXL345 is isolated in the rigid interior sensor zone.
Open items
  • No component-body or courtyard collisions were found.
  • No routing was performed; 149 airwires remain as expected.
  • Resizing removed 24 legacy GND stitching vias that were outside the new board outline; 33 in-board vias remain.
Next steps
  1. Review enclosure-facing connector, OLED, button, and LED positions.
  2. Confirm mounting-hole locations around the ADXL345 support region.
  3. Approve placement before routing begins.
I’ll read the placement-review requirements, compare them with the current 100 × 100 mm board, and apply any requested placement-only corrections without routing or schematic changes.
I parsed the compact-placement requirements and prepared the full placement brief, but no board changes were made because no ACUs remain.
Remaining work:
  • Add four mounting holes and mechanical keepouts.
  • Re-place all components from scratch near the 70 × 60 mm target.
  • Iteratively shrink and verify RF, ADXL345 rigidity, regulator clusters, connector access, collisions, and overhangs.
  • Produce the requested datasheet-compliance and dimensional report.
  • Stop before routing, as specified.
Set board and place
Clarify mechanical constraints
Placement compliance report

Waiting for input


Last modified 3mo ago

Firmware Getting Started
GPIO table from actual schematic

Table


ESP32 pinNet / functionNotes
GPIO21I2C_SDAADXL345 and future OLED
GPIO22I2C_SCLADXL345 and future OLED
GPIO23SD_MOSImicroSD SPI
GPIO19SD_MISOmicroSD SPI
GPIO18SD_SCKmicroSD SPI
GPIO13SD_CSActive low
GPIO36SD_DETECTInput-only
GPIO25ADXL_INT1Interrupt input
GPIO26ADXL_INT2Interrupt input
GPIO4OLED_RESETReserved; OLED unresolved
GPIO27LED_RActive-high MOSFET gate
GPIO32LED_GActive-high MOSFET gate
GPIO33LED_BActive-high MOSFET gate
GPIO34BTN1Input-only, external pull-up, active low
GPIO35BTN2Input-only, external pull-up, active low
GPIO1 / U0TXDUART_TXESP32→CP2102N RXD
GPIO3 / U0RXDUART_RXCP2102N TXD→ESP32
GPIO0ESP_BOOTStrap; manual and automatic boot, active low
ENESP_ENManual and automatic reset, active low
ESP-IDF startup
Set target esp32. Initialize LED GPIOs low before enabling PWM; configure buttons/card-detect as inputs; initialize I2C on GPIO21/22 and verify ADXL345 address 0x53; initialize SPI on GPIO18/19/23 with CS GPIO13; then mount storage and start application tasks. OLED initialization must remain conditional until the panel is sourced.
Programming
CP2102N DTR/RTS now drives the cross-coupled auto-program circuit while SW1 BOOT and SW2 RESET remain available. Use idf.py build flash monitor.
  • GPIO table from actual schematic

  • ESP-IDF startup

  • Programming