555 Timer Ignition Coil Driver Design
Worked for 2 mins 52 sec
Parts are selected: NE555P, IRF840 TO-220, screw terminals, a high-voltage TVS clamp, and a 1N4007 supply-protection diode. I’m adding the timing network and required 555 decoupling now.
Worked for 4 mins 46 sec
I renamed the project to 12V 555 Ignition Coil Driver, set a matching description, selected library-backed parts, consulted the NE555 and IRF840 datasheets, added the schematic components, and wired the main circuit.
Current schematic includes:
- U1 NE555P astable timer on a protected 12 V rail
- Q1 IRF840 low-side MOSFET coil switch
- J1 12 V input terminal
- J2 ignition coil primary terminal
- D1 P6KE200A TVS flyback clamp from MOSFET drain/coil low node to GND
- D2 1N4007 reverse-polarity protection diode for the 555/control rail
- Timing network: R1 1 kΩ, R2 6.8 kΩ, C1 100 nF for roughly 986 Hz
- Required 555 support: C2 10 nF control bypass, C3 100 nF decoupling, C4 10 µF bulk
- Gate drive: R3 47 Ω gate resistor, R4 100 kΩ gate pulldown
Blocked now because the account has no available ACUs, so I couldn’t run the final design review or fix any ERC/DRC findings. Remaining work: run review, resolve any violations, then create bring-up documentation before moving to PCB layout.
Run design review
Adjust to 100 Hz
Check gate drive
Add safety note
Plan PCB layout
Welcome 👋
Flux helps you build PCBs faster with an AI teammate!
Create your account to collaborate, stay updated, fork your own version, and get instant answers from our AI agent.