Importing Altium PCB Project Issues

flux

Updated M.2 SDR 4RCV Layout Symmetry Checklist.
Added:
  • A dedicated stackup and controlled-impedance section
  • Explicit 4-layer target
  • Copper-weight targets for outer and inner layers
  • Dielectric target ranges for L1-L2, L2-L3, and L3-L4
  • Controlled-impedance guidance for 50 ohm RX lanes and 100 ohm differential nets
  • Notes on keeping all four RX lanes on equivalent layers/geometries
  • A fabrication record table for final solved widths, gaps, copper, dielectric, and via policy
If you want, I can next tighten this further into a specific 4-layer fabrication proposal with first-pass trace-width placeholders.
J

jmackay410

Add that to the project spec as a PCB stackup section with 4 layers, 1 oz outer copper, 0.5 oz inner copper, 100Ω differential and 50Ω single-ended targets.

flux

Added to Project Specification.
Included:
  • 4-layer PCB stackup
  • 1 oz outer copper
  • 0.5 oz inner copper
  • 100 Ω differential target
  • 50 Ω single-ended target
  • notes to solve final widths/gaps from the fabricator stackup and keep matched RX routes layer-consistent
If you want, I can also add a recommended layer role table next, like L1 signal, L2 ground, L3 power/signal, L4 signal.
Add layer roles
Include impedance notes
Add stackup constraints
Sign up to send
No schematic yet

Talk to Flux to get started.

No layout yet

When components get added to the schematic, they'll show up here.