3D Model Repair
Thought for 34 sec
I’ll inspect and repair the 3D model, then check its fit and loading. I’ll leave the pins, pin mapping, symbol, and 2D footprint unchanged.
Thought for 18 mins 34 sec
Thought for 15 sec
Created 2 tasks.
1/2 Repair or rebuild the package model without changing electrical or footprint data.
Repair or rebuild the package model without changing electrical or footprint data.
Verify 3D rendering and confirm protected part data is unchanged.
Thought for 19 sec
Awaiting 1 task
Thought for 18 sec
Reading "3d-repair-report" project doc.
"DMP2012SN-7 3D Model Repair" completed.
Thought for 55 sec
The replacement parametric model compiles and renders with all three leads aligned, and the protected part data is unchanged. I’m checking one remaining issue: the assembled render shows a seating-height discrepancy, so I haven’t yet confirmed the original 3D-tab crash is resolved.
Thought for 2 mins 1 sec
Thought for 18 sec
Awaiting 1 task
"DMP2012SN-7 3D Model Repair Review" completed.
Thought for 1 min 27 sec
I rebuilt the parametric model; it now compiles and renders, with pins, pin mapping, symbol, and pads unchanged. A seating-height discrepancy remains in the assembled render, documented in the repair report, and needs Flux Support investigation.
Can you reload the 3D View tab and confirm whether the original crash is gone?
Waiting for input
