// Howdy 👋.
//
// This is where you can create powerful part automations like resistors that tell you when too much current is flowing through them
// You can also create your own flexible parts, like generics (https://docs.flux.ai/Introduction/generic-parts)
//
// If you are new to writing code in Flux make sure to check out our get started docs: https://docs.flux.ai/reference/introduction
//
// We also have a Flux Slack Community in case you need help: https://join.slack.com/t/fluxcommunity/shared_invite/zt-2hi664box-TNSNJ_~nUkNHkxeULXkSog
//
// To infinity and beyond 🚀
#include < Arduino.h >
#include < Wire.h > // Include the I2C library (Wire library)
// Define the I2C address of the sensor. Adjust this based on your sensor's datasheet
// The address below is just a placeholder. Replace it with the correct one.
#define SENSOR_ADDRESS 0x76
void setup() {
Serial.begin(9600); // Start serial communication at 9600 bps
Wire.begin(); // Initialize I2C communication
Serial.println("Initializing the pressure sensor...");
// If your sensor needs specific initialization, do it here.
}
void loop() {
byte msb, lsb, xlsb; // Variables to store sensor data
unsigned long data; // Variable to combine the data
// Start communication with the sensor
Wire.beginTransmission(SENSOR_ADDRESS);