Checks that the power traveling across a given resistor is under its rating with 50% headroom.

Checks that IC pins that require pull up or pull down resistors have them.

Checks that capacitors have appropriate voltage ratings to prevent overheating and ensure reliable circuit operation.

Checks that all parts have a part number and are available from distributors.

Reports issues with Auto-Layout if Copilot cannot route something or must ignore a configuration.

Reports copper elements that are shorting.

Reports parts that have no footprint.

Reports nodes that are assigned to a layer that doesn't exist in the layout stackup.

Reports terminals that are not connected properly. NOTE: Only connections to the center of pads are considered valid.

Reports nodes that are using rules that are not supported anymore.

Reports layers that have multiple copper fills of different nets. Make sure the Connected Layers rule value of nets with fills is valid.

Detect any via, trace or copper fill island that is not connected to any net.