I started the module-based prototype plan, but I can’t continue executing because there are no available ACUs right now.

What’s defined so far:

What remains:

No PCB changes were made. The requested board would use an ESP32-C3 SuperMini module footprint with solder pads, but I couldn’t create or modify the project because execution stopped before schematic/PCB work began; this project also has comment-only access.

Remaining work is to create or fork an editable board project, add the verified ESP32-C3 SuperMini module footprint and pad mapping, define the board outline, then place and validate the solder pads. Execution stopped because your ACUs ran out.

I can create a blank PCB, but not in this project because you have comment-only access. No project or board was created this session.

Create or fork an editable project, then I can define a simple blank rectangular PCB—defaulting to 50 × 40 mm, 2-layer, 1.6 mm FR-4 unless you specify another size. Execution is also currently stopped because your ACUs ran out.