Power net portal is a special schematic object used to define a power or ground net. Power ports allow you to conveniently indicate a power net at any location in the design. Power nets of the same designator automatically connect throughout your design #portal #power
A generic fixed inductor for rapid developing circuit topology. *You can now change the footprint and 3D model at the top level anytime you want. This is the power of #generics
To simulate a potentiometer, particularly the Bourns 3296Y 10 kOhms potentiometer in your project, you would need a software that supports custom components or has the ability to simulate variable resistors. Since Flux.ai focuses on design and layout and does not include a simulation feature, you'll need to use external simulation tools. Here's a general guide on how to simulate this potentiometer in simulation software:
Choose a Simulation Software: If you don't already have a preference, consider using LTspice, Multisim, or TINA-TI, all of which are suitable for simulating circuits with potentiometers.
Create the Potentiometer Model: Since you are simulating a 10 kOhms potentiometer with a 25-turn adjustment, you can do so by modeling this potentiometer as two resistors in series where the total resistance across them is always 10 kOhms. The resistance of one will increase as the other decreases, simulating the wiper movement.
Implement the Model:
Define two resistors, let's name them R1 and R2.
The total resistance across R1 and R2 should be kept constant at 10 kOhms.
The value of R1 can be varied from 0 to 10 kOhms, where R2 = 10k - R1.
Many simulation tools allow you to vary a parameter during the simulation, so you can assign a variable to R1 that you can sweep through its range.
Simulation Setup:
Connect the first terminal of your potentiometer model (P1:1) to the circuit where the fixed terminal of the potentiometer goes.
The variable wiper would be simulated by the node between R1 and R2. This is your middle terminal (P2:2).
Connect the third terminal of your potentiometer model (P3:3) to the circuit where the other fixed terminal of the potentiometer goes.
Setup your simulation to sweep through the range of R1, effectively simulating turning the potentiometer's knob.
Run the Simulation:
Run your simulation across the desired parameters, observing the impact of adjusting the potentiometer on your circuit's behavior.
Adjust Based on Results:
Use the results to adjust your real-world design as needed.
Given the details of your project, the key assumption here is that you want to model how varying the resistance affects your circuit without specific details on how it's integrated within your project. If you have more specific requirements or a part of the circuit you are unsure how to simulate in relation to the potentiometer, please provide additional details for more targeted guidance.
11mo
Hey, I'm copilot! I can help you with all kinds of stuff in your project. Reac...
Hey, I'm copilot! I can help you with all kinds of stuff in your project. Reach me at any time by tagging me on comments or in the chat with my handle, @copilot.
1y
Someone is typing...
Passive Components
Resistor Power Rating
Beta
Checks that the power traveling across a given resistor is under its rating with 50% headroom.